For Sale - Trade - Wanted

Somewhat active, I guess…. lol I don’t do too much on the Rincon 680s but send a picture and a few historical details about what happened Usually when you see LED lights and no display I usually find it they have water damages inside Let me know what you find -AKATV

not mine, i just fixed it, well..the best i could seeing how the owner is a cheap s.o.b. , lol. top end, new starter, new battery, rear brakes back together, front brakes work, he's asking $ 1,500.00 as is, cash only. no, i will not ship !. pick up on your dime..lol.

ya know...if all you over weight folks would go on a diet ?, you would not need better shocks ?!..lol.

of course..the most high dollar part there is..lol ( unless you buy used anyway )..lol.

advice is free...parts are not !..lol. first off, complete engine gasket kit. tube of yamabond ( for where there is no gaskets ONLY ! ). all engine oil seals, D.I.D. cam chain is what i install in all my builds. 3 qrts of atv oil, oil filter, spark plug. air filter. only spec tools you will need: valve spring compressor ( if you do not have one ? ). flywheel puller, centrifugal clutch puller tool. a seal puller ( but not really needed, but works easier than prying seals out with a screwdriver ). service manual for sure !!. have your camera ( cell phone ) on hand to take lots and lots of tear down pics, before, during, after. this way, if you get stumped?, you can always go back, look at pics to see where that thrust washer goes ?..lol. if it were me ? ( i know its not..lol )..i would replace the main crank bearings while you have it torn down, yes..its extra money, but i would do this now, and be worry free for a few more yrs !. a good metric socket set, brass hammer, pry bars, air compressor, air impact gun ( 1/2 ), deep impact sockets, you will need 27mm, 24mm, 22mm, here and there. you can never have enough impact sockets !. some cases, you will need a 30mm, 29mm, 28mm. these come in handy for the hub nuts. not needed, but handy..A PARTS WASHER !. this comes in very handy to rinse out the cases once you get it all part, yes..i go that extra mile when i build my engines. if you get stumped ?, we are always here to help !, myself..i also do phone support..lol.