Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 06/28/2020 in all areas

  1. 5 points
    spent time today down there today, left house here around 5 am, got down there, started mowing yard, 3/4 way through, it started to rain. grrr. said ok, i will install the new toilet for now. got that done, then put insulation around all the pex pipes, used hanger straps to attach the pipes under the floor. got all that done, by that time the rain stopped, finished mowing the yard, packed it all up, came back home. was beat, ate, took a shower, fell asleep, just now woke up. just need to treat the deck with some water treatment, and the outside will be completely done !.
  2. 3 points
  3. 2 points
    We have enough mosquitoes, flies and ticks here that it keeps alot of people from moving here.
  4. 2 points
    Taking advantage of people in desperate times. What a strange brag.
  5. 2 points
    I found that I forgot to order the trimpot retro mentioned. Found this Bourn PV36 10KOhm 25-turn he described. https://www.mouser.com/ProductDetail/Bourns/PV36Y103C01B00?qs=pFP7BvE1PmwQfgsP8uFHEw%3D%3D i wired up the trimpot retro sent me and now ready to test. My TRX350A uses a two-wire sensor so wiring in the trimpot in circuit parallel allows me to lower the overall circuit resistance (Ohms law: resistance in series is summed while resistance in parallel is averaged). The trimpot curve Might not match well with the sensor curve just have to try it. I gutted two of my worst sensors—used a dremel with cutting wheel to remove the steel wire protector. The wire terminals are protected by a red rubber plug and potting below. I used a jewelers screwdriver to dislodge the plug. Scraped out the potting. The wires are terminated at a disc used to mount the thermistor. clipped the wires off and saved them. the thermistor is mounted in more white potting so i Used a torch to cook it and then pulled it out by the wire terminations with needlenose pliers. i then used a drill bit and bore brushes by hand to remove all the remnants of potting.
  6. 2 points
    I wonder if Trudeau got beat half to death with a brick if you would have to get a special permit to build with them. Anybody that owned a brick that was not mortared to a structure would be a felon.
  7. 1 point
    i don't do leak down test, by the time i put new rings in, service the valve seats and valves ( clean them ), fresh hone or bore, new piston, i don't worry about it not running.
  8. 1 point
    I thought about that , think there must be something made into the Rick's CDI that makes it compatible with 88 -93 , Rick's has been selling them for a long time now , would think if there was a problem it would have arisen long ago ------- my buddy's theory is that the red plug CDI's are the ones with no PRM limiter built into them , but from what I remember , 88-93 was all no RPM limiter years ------- my plugs are white , but that CDI may have been changed before Hot Shot Honda CDI Box: This Rick's Motorsport Electrics Hot Shot CDI box is made with heavy duty components; no specific enhancements. Retail Price: $81.95 Price: $81.95 THIS PART FITS THE FOLLOWING VEHICLES: Hot Shot Honda CDI Box 15_612 for a 1988 Honda ATV TRX300 Fourtrax Hot Shot Honda CDI Box 15_612 for a 1989 Honda ATV TRX300 Fourtrax Hot Shot Honda CDI Box 15_612 for a 1990 Honda ATV TRX300 Fourtrax Hot Shot Honda CDI Box 15_612 for a 1991 Honda ATV TRX300 Fourtrax Hot Shot Honda CDI Box 15_612 for a 1992 Honda ATV TRX300 Fourtrax Hot Shot Honda CDI Box 15_612 for a 1993 Honda ATV TRX300 Fourtrax .
  9. 1 point
    During the obama administration , I had read where the government was buying up bullets by the millions thru different offices , like Departments of Human Services and such , I think now that I see where the plans being brought up with Departments becoming the new police force , it makes sense now , the plans were in the making -----I think what is happening now was planned , but it was suppose to be under a different President , could only imagine what would be going on right now with Hillary or Joe in control
  10. 1 point
    it's kinda funny in a way, the dem's who stirred up this movement. a Dem. congressman got beat up. now he is singing a different tune. sow the wind, ya reap the whirlwind.
  11. 1 point
    actually the gun / ammo shortage started with the panic over the carona .... virus .... (covid) and the news causing fake panic and most people who think ahead always stay stocked up ... but not just on ammo .... but food stuffs .... and other supply's .... as FOR the beatings .... that's on the lack of law enforcement .... because of the dems ... allowing the anarchist .... to voice .. there thoughts ... and cause chaos .... although ....it is just plain bad ... and it's the people that oppose this movement who are being targeted ....
  12. 1 point
    Watching a guy get buried. And a short clip of riding before the gopro battery died. I did get one other clip of some riding but totally forgot to charge the gopro and i also didnt have time to aim it so the visor is in the way some. Real poor preperation on my part.
  13. 1 point
    How’s if i share the link? https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F232093744994
  14. 1 point
    well..... it might not ever change back.... but I'm in for the payback .... just like the drivers are .... (or seems like) bubba was the 1st car one lap down .... the only (push) he got was from Larson... and he couldn't even make that work to his advantage .... in this sport i don't care about the propaganda .... I'll wait for payback on the track.... that's the way it's always been between race drivers who actually made this sport what it is .... yet no comments from bubba after the race ?
  15. 1 point
  16. 1 point
    @Wheeler, loop holes aside, if I could only own a gun to take to the range it wouldn't be worth it. I understand it's not necessarily that bad to bring a hunting gun but I quit hunting there when they started all the BS paperwork. Before we could just pull up to Customs, tell or show them our guns and how much ammo and we were on our way. When I am up there fishing I am not too fond of hiking or picking berries back in the bush where you might encounter some belligerent bears etc.
  17. 1 point
    I love going to Canada and have some friends there. However, your firearms laws have discouraged me from hunting there and I would certainly never live there based on that alone. I realize this comes primarily from your city liberals. Surprised they haven't outlawed bats, knives, pipe, chains etc.
  18. 1 point
    Haha i know right! The house wasnt even all that big. Had 2 high efficient furnaces. 2 central air units. And then a ducted mini split for the upstairs. I guess they want to turn the entire place into a freezer maybe? Not sure? Its ohio. Not the sahara lol
  19. 1 point
    you do not screw the dip stick in, you lay it in the hole, then check it.
  20. 1 point
  21. 1 point
  22. 1 point
    got the top part, and steps done. time for a break now from it.
  23. 0 points
    The guy that flipped the barge and was crushed by the excavator passed away yesterday morning
  24. 0 points
    There might be a brown bacon stripe on the backside he is enjoying....just saying 😳🥺
×
×
  • Create New...