Blue1991

Wiring is good haven’t ran the engine yet but I can manually shift it through all the gears and it reads the gears on the dash. I’m leaning towards the angle sensor. Going to test it when I get home that should tell me if it’s good or bad if I’m correct. Thanks again guys for all the help.

Alright so I got the engine tore down. found that the bushing that reverse gear and first gear rides on had welded itself to the gears. so they were both trying to turn at the same time. New issue is now that I’ve got it all back together, when I turn the key on the neutral light blinks 8 times. Code said could be shift motor, angle sensor or the wires that control them. I’ve read a little but haven’t made much headway on the angle sensor. Some that I’ve read says has to be put in a certain way then turned to line up bolt holes some say put it in and do a series of steps with the shift buttons and the key. Wondering if you guys might could help me out here again. Shift motor was shifting through gears fine before just was stuck in reverse due to gears in the trans being locked up. Checked shift motor with a hot and ground and shift motor works.

Ok I’ll try that. Thanks. Thing that has me confused is when I put it in first manually it also like it’s in a bind almost like it’s stuck between gears if that makes sense. Like it wants to go forward but it’s still in reverse.

Yeah it will I put an 8mm socket and got it to shift up and down but it’s still in reverse. Even in neutral when the light is green and the gear position says N where it should be in neutral it still is in reverse when you give it throttle.

Alright I’m new here trying to figure this out. so I was riding normal riding on my hunting lease. 5th gear easing along all of a sudden it stops like the rear end locked up. Got it home and got it into neutral and the shift motor lets it shift up and down reverse works perfect but it’s also in reverse in neutral and every other forward gear. Just trying to figure out if it may be something simple or if it’s going to be something internal. Shift motor works perfect also. Any help would awesome!