Jump to content
Kipes

Pioneer 1K

Recommended Posts

I have a 18 Pioneer that started stalling on me when I get on the throttle and it seems to be getting worse. The engine light starts blinking and it dies, turn the key off and it starts right up. Any idea where to start looking? TIA.

 

Share this post


Link to post
Share on other sites
 
 
 

Remove the cabin seat back and crap little black cover. With it running play with the wires going to the injectors and you might find a bad one. It's common enough you can buy the pre wired connectors all over the web.

Share this post


Link to post
Share on other sites
 
1 hour ago, toodeep said:

Remove the cabin seat back and crap little black cover. With it running play with the wires going to the injectors and you might find a bad one. It's common enough you can buy the pre wired connectors all over the web.

Thanks toodeep, I will try that.

 

Share this post


Link to post
Share on other sites
 

Put dielectric grease in the injector connections and the three plug ins under the drivers seat and it's fine now. Thanks for the input.

 

  • Like 1
  • Thanks 1

Share this post


Link to post
Share on other sites
 

Well it was good last summer but now it started dying out even more frequently. Jiggled the injector wires and it died. Replaced the bad one and hopefully it's all good again. Thanks Toodeep!.

 

  • Like 1

Share this post


Link to post
Share on other sites
 

Yep, old thread, but if I found it, someone else can also.

Here is some additional information.

.

The (CEL)Check Engine Light blinks if there is a Fuel/Ignition issue.
DTC (Diagnostic Trouble Code)
In the Service Manual, DTC codes start on page 4-9
.
The gear indicator light blinks if there is a transmission or driveline issue.
DCT (Dual Clutch Transmission)
In the Service Manual, DCT codes start on page 11-11

.

A long blink is a 10
A short blink is a 1

.

Flash codes for fuel injectors:

 12 Front fuel injector circuit malfunction(12-1)
 13 Rear fuel injector circuit malfunction(13-1)

.

As @toodeep said, you can get the injector wire ends many places online.

I have 2 on hand, for when mine go bad.
The little wires inside the wire terminal crimp break.
It is Highly recommended to change them both.

.

Here is a good YouTube about it.

.

Have a good day

  • Like 1

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...