PROV 1,440 Posted April 20, 2020 You know you can upload them to Basecamp if you want to save them right? 1 Share this post Link to post Share on other sites
Akunin 343 Posted May 6, 2020 My 680t had done something similar, only to find I was in the wrong profile. I dont recall what I was using but it kept the tracks from being shown. Once I switched the profile they were there. Wish I could remember which profile it was... not much help but wanted to share! 1 Share this post Link to post Share on other sites
Fishfiles 20,145 Posted May 6, 2020 9 hours ago, Akunin said: My 680t had done something similar, only to find I was in the wrong profile. I dont recall what I was using but it kept the tracks from being shown. Once I switched the profile they were there. Wish I could remember which profile it was... not much help but wanted to share! I have played with it and can't seem to figure it out , I must have hit something , tried do a reset to default and that didn't help ---- the bread crumbs are being saved as when I upload to Base Camp I can see them , they are just not showing up on the trails as they are being produced ---- I know what to do , stupid of me to not think of it before , Call Garmin , they have always been every helpful to me in the past , this is about the 8th Garmin I have ---------- years back I set up a lap top with Capt Jack software for fishing , Capt Jack was used at the time by the Coast Guard , and they went well past the norm to help me thru some interface problems , after Katrina flooded one of my units and I sent it in for refurb , they sent it back no charge Share this post Link to post Share on other sites
Melatv 788 Posted May 6, 2020 Hi Fish: Go to setup -- Select tracks -- Track log -- Record -- Show on map 1 Share this post Link to post Share on other sites