Jump to content
87Iroc

Hole too big in plastic.

Recommended Posts

Was going over some of push pins in my foreman and found one with a hole in green plastic that was too big to hold pin. Did this. Not sure if this is a hack you guys do or not.  
 

5/16 flat washer on back side. 
 

I am finding several pushpins not holding tight and washer is cinching them down again great.  

 

612B9448-004F-4847-9766-C585BCDAE481.jpeg

Edited by 87Iroc
  • Like 3
  • Thanks 1

Share this post


Link to post
Share on other sites
 
 

Yep, a washer will tighten up a wallowed out hole and still allow you to use push pins.  Much better fix than a bolt and nut.

  • Like 3

Share this post


Link to post
Share on other sites
 
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...