struthers
Members-
Content Count
62 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Gallery
Calendar
Everything posted by struthers
-
@jeepwm69 after I adjusted the tps it got spark but wouldnt start, then replaceing the flywheel got it to run, the other flywheel had rust build up on it, from the previous guy before me leaving the cover off.
-
@jeepwm69 okay
-
@Melatv @jeepwm69 any idea where to go from here
-
@Melatv @jeepwm69 new OEM key switch has been put on, still no spark though.
-
@Melatv @jeepwm69 yeah I just bought a new oem one
-
@Melatv could that be the cause of my issue? Why would it still crank and everything.
-
@Melatv thank you for the help, here are my results. Red to Black reads OL Red to Pink reads OL Black to Pink reads OL
-
@Melatv I've unpluged it to not run down the battery
-
@Melatv no but I can put them back in
-
@Melatv I am seriously considering that the wire harness is the only other issue it could be
-
@Melatv charging battery, I do see voltage at blue and yellow and white wires at CKP, the ohms are about 248 ohms
-
@Melatv
-
@Melatv the battery did pass your test and with my load tester it did pass as well but on the lower side
-
I have a battery load tester I will put on it and I will try what your saying.
-
@Melatv I will look into some more come Sunday having family over at the moment, the battery I have has a digital indicator on it that shows the voltage and it wasn't showing low
-
@Melatv okay the pins look to be in good condition, the ecm plug i dont notice any corrosion. B/Y from the ECM to the B/Y that goes to the coil reads about 0.2 ohms
-
@Melatv with boot on to ground I still get that 11.49k ohms reading no matter how hard I push down or wiggle it
-
@Melatvokay i the B/Y wire is off the coil I have removed the spakr plug wire from the spark plug and from the boot and tested the spark to ground still no spark
-
@Melatv that's without the spark plug boot, with the boot on I get a reading of 11.49k ohms
-
@Melatv from the spark where the B/Y wire was plug into, to the end of the coil wire im getting 5.706k ohms
-
Do I need to take the green wire off the coil?
-
@Melatv from the green wire to the negative battery post I get .3 ohms
-
@Melatv okay I'm getting 0.2 ohms
-
@Melatv okay now it will work at the start button I tightened my connectors, it turns over at the start button, just still no spark.
-
@Melatv okay I actually found some wire and made jumpers I'm getting power on now light come screen comes on, but it won't turn over from the start button. I am getting 11.44 volts now out of ignition fuse location, i got about 12 volts at the battery.