gareth.campbell

All the ground connections have been cleaned up and continuity checked. The kill switch is in the center ans the neutral light is on.

I bridged the crank position sensor with a piece of wire. The first time I bridged it the bike started straight away. But now I'm have no luck at all. The brake switch seems to be ok as far as i know. If you put the bike in gear and pull the brake leaver the bike will crank over but not start.

I have a 2011 Honda trx420fm that will not fire. It turns over fine and the fuel pump kicks in when the ignition is turned on, the lights on the display operate as they should. I have power at the coil constantly but no negative and no spark (new spark plug). I have replaced the ECU and the fuel pump relay and the engine stop relay. I did get it going a few weeks ago and it was running fine once I bridged the crank position sensor. Now it wont start at all even with engine start spray. Any advise would be much appreciated.