Baz

Thanks very much for the advice

Thought that was the wire you were talking about, would that card be repairable/salvageable? Or just stick with it as it is?

Issue found I think after 2 plugs on rear of PCB removed

See attached some photos of what the PCB and other parts look like after opening it up today

Hi @AKATV When I bought the quad, the display had some errors before, so it only shows the Kms travelled and the clock, the buttons to change these don't work but the Kms travelled still count up but the clock is always reset to 1:00 when I start up the quad. The Kms figure hasn't reset following this error that's developed, only thing I've noticed is that the gear position isn't shown. When I turn on the ignition before starting the engine, the display goes through a boot up sequence, that shows each available gear that takes about 10 seconds before resting at the normal display and the gear numbers do show but only as part of the display boot up, if that makes any sense! Possibly the bottom of the PCB has been in water for an extended period, hence the push buttons on the display don't work

Hi All, New member so any help appreciated! Recently bought the above at auction and works great so far, no major issues that I haven't managed to fix myself. Been away for 2 weeks with work and returned home to a dead battery (not a surprise as think it sat dead for a few months before I bought it) put the charger on and fired up straight away and going through the gears no problem but have noticed that the gear selector indicator on the display is just blank. No flashing N no -- displayed just totally blank. As a bit of background the display did have some water in it when I got it so took it apart and drained/dried best as I could although some minor moisture still may be present within the display but was using the quad in heavy rain about 3 weeks ago but no other issues with the ES system, gears all change fine, just doesn't display the gear it's in. Any help greatly appreciated!