monstermash 3 Posted May 11, 2022 Hey guys, New to the forum. Helping a friend with a problem on his 2016 Rancher 2wd ES. Believe its a 420, the manual shift lever is a straight handle. During a recent ride the atv began to abruptly quit at idle. Not dying due to a fuel issue, basically it's like throwing your manual transmission car into gear without ever pressing in on the clutch. When it's stopped running, you can shift back to neutral just fine, starts and idles great in neutral, hit the shift up button and it jerks and dies. If you hit the gas just as you shift up, you can get going and run through the gears just like normal. But if you let it come back down to idle, in any gear, it will jerk and die. Just like stalling a car. I found another post on a different site advising to take the manual shift lever and hold up on it like you're shifting and rev the motor, hopefully causing the clutches to disengage, but no luck. After doing that get the 2 flash code indicating shift issue, but that only happens after I tried the fix, not all the time. Any thoughts? is this an expensive repair? Thank you so much for any guidance you can give. Erik P.S. this atv may have been run a lot in low gears, he wouldn't let his kids get it above 2nd gear. Share this post Link to post Share on other sites
Fishfiles 17,026 Posted May 11, 2022 Welcome to the forum , might be as simple as a clutch adjustment , do you have a manual ? This should be your : https://drive.google.com/drive/folders/12hzs10L_Gwu0aVyp8vhmEXNdf2N2P7tk How did you come up with that name ??? Pretty Cool Share this post Link to post Share on other sites
monstermash 3 Posted May 11, 2022 Thanks Fishfiles, my last name is Mash, so the nickname came pretty easily. I don't know as he has the manual, thanks for the link, I will see what I can find. Didn't know if this was a common issue. Really annoying. If you work the gas right, the atv runs great. 1 Share this post Link to post Share on other sites
Fishfiles 17,026 Posted May 12, 2022 @monstermash did you adjust the shift clutch yet ? ---- Share this post Link to post Share on other sites
monstermash 3 Posted May 12, 2022 Hey Fishfiles, I have not tried it yet, son has a hs fishing tournament this weekend, so we are getting ready for that. I'm going to take a stab at it Sunday. Thanks again for that manual download, it's exactly what I needed. Erik Share this post Link to post Share on other sites
Fishfiles 17,026 Posted May 12, 2022 4 minutes ago, monstermash said: Hey Fishfiles, I have not tried it yet, son has a hs fishing tournament this weekend, so we are getting ready for that. I'm going to take a stab at it Sunday. Thanks again for that manual download, it's exactly what I needed. Erik Fishing tournament , now your talking my language ---- speckled trout are on fire in Lake Ponchartrain right now There is a 14mm hex headed adjustment lock nut on the case , in the middle is a flat head screw driver slot , just a matter of loosen the jam nut , turning the adjuster screw till tension is felt , then loosening 1/4 turn and lock the jam nut , the case is engraved with an arrow and increase ---- How does your oil look ? Clean ? Share this post Link to post Share on other sites
monstermash 3 Posted May 12, 2022 Oil looks good. Yes, my son fishes the Bass Nation HS circuit in west TN. Going to Pickwick tomorrow. 2 Share this post Link to post Share on other sites
