Bossdaddy

Meter set on 200 1 meter reads .5 another meter reads 1.2

I will ck it again 

If we need to poke holes that’s ok I can repair insulation. 

16 p unplugged, 5 p bl/o to bat neg reads 105, o to g/b reads 0.00. 

16 p plugged in?

W/y good, found another w/b and it’s good. 

I got no response from either reading on meter, it acted like I never hooked it up. 

I got 5.7v on harness side

I got 5.08 on male plug

Help me , which connector is that, location

Yes, starts and runs. With key on neutral light is on and temp light comes on and goes off, sometimes temp light stays on.

Battery reading  12.4 v, after lights on 30 seconds 11.81v, after lights turned off  12.15v

I believe in these guys and I'm not giving up on them. I'm worried more about if I'm doing my part right.

I appreciate the effort, I'm afraid I did some of the test wrong and gave you the wrong data. This thing was shifting perfect and quit for no reason just being used normally then for no reason it started shifting normally again for about two days then quit again and has never shift again.

Thanks Fishfiles, very interesting stuff. If all fails I might have to look in to this, I think these guys will get me fixed up.

I don't have a clue about what is left to check. I haven't heard from anybody for a while, I thought maybe y'all had given up on this one. I knew you had visitors and I'm sure Melatv has a life besides messing with me all the time. I'm afraid we are not going to find anything. Then I'm screwed. Anyway glad you're back on.

I do have continuity on the green wire. 

retro, by the time you get back Melatv will be ready for some relief after dealing with my old butt, I do appreciate all the help I'm getting.

Melatv, I do have 12vdc. 

Ok, I need to make sure I do this right. Jumper in on r/w and r/y, unplug ECM to me thats the 16p connector, then unplug 5p connector and test r/y harness side and black probe to ground.

No, I had a jumper installed.

Yes. neutral

Yes, I did get 12 vdc on the r/w and g connectors

I know your frustrations, your dealing with somebody that don't know crap about the electronics of the bike. The engine relay is the the one I had the jumper on? 

I finally got a chance to do another check. Jumper installed, key on, both probes in connector, pushed buttons and got no readings.