Jump to content
F250 guy

95 300 4x4 reverse lever pin popped out.

Recommended Posts

I went to shift into reverse on grandpa's 300 4x4 and the pin popped out. Is there a clip that holds it in the bracket that can be replaced or buy the whole bracket?

 

The red button you push down that pulls the reverse cable. 

 

I looked on mine and I can't figure out what holds it in. My mom wants it fixed. 

 

That's a general picture, the actual button I can put it in but won't stay in.

hqdefault (2).jpg

Share this post


Link to post
Share on other sites
 

 >>>  Do you'll know it is only good for one push and pull then needs to be done again for the next reverse adventure 

  • Haha 1

Share this post


Link to post
Share on other sites
 
21 minutes ago, Fishfiles said:

 >>>  Do you'll know it is only good for one push and pull then needs to be done again for the next reverse adventure 

I sure do, I wasn't sure if you could take it apart but after looking up a diagram it's built in the lever, I found em on ebay 18.00

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...