rich250rracer 2 Posted May 9 46 minutes ago, shadetree said: did you locate the diode in the wire harness ( i am not sure there is one ? ) if this diode is bad ?, you won't get power to the gear position switch. Gear indicator on the dash indicates every gear, so I don’t think there is one. Share this post Link to post Share on other sites
Melatv 797 Posted May 9 @rich250rracer -- You are right -- there is nothing wrong with the gear position switch -- there is NO hot voltage on the gear position switch -- all 7 wires are grounded one at a time as you go through the gears. Share this post Link to post Share on other sites
shadetree 5,970 Posted May 10 5 hours ago, Melatv said: @rich250rracer -- You are right -- there is nothing wrong with the gear position switch -- there is NO hot voltage on the gear position switch -- all 7 wires are grounded one at a time as you go through the gears. well then, honda in their wisdom changed it , my luck..lol. Share this post Link to post Share on other sites
shadetree 5,970 Posted May 10 6 hours ago, rich250rracer said: Gear indicator on the dash indicates every gear, so I don’t think there is one. ok..according to mel ( you were right ! )..i'm bowing out of this.above my pay grade..lol. good luck !. Share this post Link to post Share on other sites
retro 4,073 Posted May 13 @rich250rracer, my laptop went down and I am now limping along on my backup/spare laptop. So until I get a new laptop up and running and get my data copied over I'll be out.... hopefully someone can help ya in the meantime. As for my situation it's gonna be a long haul, likely a month or longer. Wish ya the best! Share this post Link to post Share on other sites
jeepwm69 7,744 Posted May 13 I dropped two ECU’s and a voltage regulator in the mail earlier today. Hopefully you will have them by the end of the week to use testing Share this post Link to post Share on other sites