87Iroc 344 Posted September 11, 2020 (edited) Was going over some of push pins in my foreman and found one with a hole in green plastic that was too big to hold pin. Did this. Not sure if this is a hack you guys do or not. 5/16 flat washer on back side. I am finding several pushpins not holding tight and washer is cinching them down again great. Edited September 11, 2020 by 87Iroc 3 1 Share this post Link to post Share on other sites
87Iroc 344 Posted September 11, 2020 Better than this fix I think. 3 Share this post Link to post Share on other sites
jeepwm69 7,783 Posted September 11, 2020 Yep, a washer will tighten up a wallowed out hole and still allow you to use push pins. Much better fix than a bolt and nut. 3 Share this post Link to post Share on other sites
shadetree 6,036 Posted September 11, 2020 some of those push pins come from the factory with washers on them. 3 Share this post Link to post Share on other sites