Bigraymac 0 Posted September 4, 2021 (edited) Hi guys my Honda foreman 450 is only on 2 wheel drive 4x4 not working. Is this an expensive fix. What might the problem be*? Also the speedometer is blank there's a blurry light that's all. Can I buy a cheap replacement or get it repaired. Edited September 4, 2021 by Bigraymac Share this post Link to post Share on other sites
Melatv 797 Posted September 4, 2021 (edited) Hi: Big Welcome Here -- t Edited September 4, 2021 by Melatv Share this post Link to post Share on other sites
AKATV 851 Posted September 4, 2021 (edited) Hi Bigraymac, and welcome to the Forum! Your 4wd not working could be a few things Just to be sure, yours is an 2002 or newer with the 4WD switch on the right handlebar and led indicator on speedometer, correct? I would start by downloading the Service manual here https://drive.google.com/drive/folders/15eWwngQ5SdlsIfbgpm5ZJWJYBYx3vJ7s Your 4wd indicator should flash 2-6 times which is a code, use below chart to pinpoint fault Section 22 in the service manual can help you to repair the fault, once you determine what it is let us know what you find out Also, I can repair your speedometer if you are interested, I sent you my contact information as well -AKATV Edited September 4, 2021 by AKATV Share this post Link to post Share on other sites
bcsman 1,409 Posted September 4, 2021 Hey Big, welcome to the forum. It would help to have more info on your Honda, like year and model. The early 450's were full time 4 WD while the later, I think 2002, on had a lockout switch installed. So year and model make a Big difference..... Ha AKATV beat me to it.....lol 1 Share this post Link to post Share on other sites
Bigraymac 0 Posted September 4, 2021 Thanks for reply. I'm not actually certain of year. It's one I kinda bought blind took a chance on it. Cash buy. I'll upload a photo. Pretty certain it's a model that's constant 4x4. .I previously had Honda big red 300 2 wheel drive Share this post Link to post Share on other sites
Bigraymac 0 Posted September 4, 2021 41 minutes ago, AKATV said: Hi Bigraymac, and welcome to the Forum! Your 4wd not working could be a few things Just to be sure, yours is an 2002 or newer with the 4WD switch on the right handlebar and led indicator on speedometer, correct? I would start by downloading the Service manual here https://drive.google.com/drive/folders/15eWwngQ5SdlsIfbgpm5ZJWJYBYx3vJ7s Your 4wd indicator should flash 2-6 times which is a code, use below chart to pinpoint fault Section 22 in the service manual can help you to repair the fault, once you determine what it is let us know what you find out Also, I can repair your speedometer if you are interested, I sent you my contact information as well -AKATV Share this post Link to post Share on other sites
Bigraymac 0 Posted September 4, 2021 Thanks for sending the information Share this post Link to post Share on other sites
AKATV 851 Posted September 4, 2021 46 minutes ago, Bigraymac said: If yours is a full time 4x4 (98-01) then depending on which 2 wheels are not driving, you could have a stripped rear axle (pretty common due to water getting into axle tube through left rear wheel bearing seal and rusting out the axle splines) or a stripped or broken u-joint or bad pinion/ring gear in the rear differential if its the front wheels not working I would guess that you might have a stripped out front drive shaft of differential issues Let us know what you find out Share this post Link to post Share on other sites
Bigraymac 0 Posted September 4, 2021 Thanks. It's the front wheels not spinning Share this post Link to post Share on other sites
AKATV 851 Posted September 4, 2021 (edited) Ok, If you can see if the front driveshaft is turning, then I would suspect that the front splined cup where it connects to the input shaft of the front differential is most likely stripped out, they get water in there and rust out, similar to the rear axle splines You can pick one up on ebay or similar for fairly cheap and replace the seal and grease it up, it will last a long time Sometimes its just the splined cup and sometimes its both the drive shaft splines and the cup depending on how long it was driven in bad shape Edited September 4, 2021 by AKATV Share this post Link to post Share on other sites
_Wilson_™ 6,593 Posted September 4, 2021 HI, Bigraymac, welcome to the forums! Share this post Link to post Share on other sites
bcsman 1,409 Posted September 4, 2021 Bigray, the serial number should be stamped on the front frame, I'm trying to find which number designates the year of your 450... 1 Share this post Link to post Share on other sites
bcsman 1,409 Posted September 4, 2021 The 10th serial number digit designates the year. This should cover your 450 I would think.... 1998-W 1999-X 2000-Y 2001-1 2002-2 2003-3 2004-4 1 Share this post Link to post Share on other sites