XplicitRacing6 3 Posted January 15, 2020 Looking for recommendations on a fly wheel puller for a Honda 400ex. Thank you Share this post Link to post Share on other sites
SlammedRanger 1,512 Posted January 15, 2020 Mine is a bolt i purchased from a john deere dealer. Its a crank bolt for one of there tractors. It is grade 10 and i have used it probably 50 or 60 times. Cant remember where i found the info for it like thread pitch and stuff though. Share this post Link to post Share on other sites
jeepwm69 7,236 Posted January 15, 2020 I've just bought the cheap motion pro off of ebay. Work fine. Share this post Link to post Share on other sites
toodeep 1,737 Posted January 15, 2020 07933-3950000 Is the Honda number for the puller (20mm - 1.5 thread). https://www.ebay.com/p/1223340666 Share this post Link to post Share on other sites
F250 guy 106 Posted January 16, 2020 (edited) 13 hours ago, SlammedRanger said: Mine is a bolt i purchased from a john deere dealer. Its a crank bolt for one of there tractors. It is grade 10 and i have used it probably 50 or 60 times. Cant remember where i found the info for it like thread pitch and stuff though. Hope you didn't do any damages, or if your doing what I think you may be doing if so that's fine long as no damage happens. I thought you were prying on the flywheel and hitting the bolt dead center. That's a good way to get em off though long as one is careful. Edited January 16, 2020 by F250 guy Share this post Link to post Share on other sites
SlammedRanger 1,512 Posted January 16, 2020 1 hour ago, F250 guy said: Hope you didn't do any damages, or if your doing what I think you may be doing if so that's fine long as no damage happens. I thought you were prying on the flywheel and hitting the bolt dead center. That's a good way to get em off though long as one is careful. Nah no damage done. The 400ex flywheel puller from honda is just a bolt. They have threads in the flywheel that when you put a bolt in will push against the crank snout and force it off. The flywheel on a 400ex is on there with the force of god. I used to use in impact with a 3 jaw puller but one came off so agressively it almost broke my hand. At that point i purchased the bolt and havent looked back. 1 Share this post Link to post Share on other sites
toodeep 1,737 Posted January 16, 2020 Using a bolt or the puller I just tighten it down decent and give it one good smack with a hammer at the end of the puller. 9 times out of 10 that's all it takes to break it free.. 4 Share this post Link to post Share on other sites
