DLBeltran74 47 Posted August 5, 2021 Has anyone ever heard of wilwood for a four wheeler!?! Share this post Link to post Share on other sites
Fishfiles 20,147 Posted August 5, 2021 That could be a Highlifter disc conversion kit , caliper made in the USA ----- 1 Share this post Link to post Share on other sites
AKATV 850 Posted August 5, 2021 Most Wildwood brake master cylinder and caliper assemblies I have seen were on the earlier Arctic Cat ATV models https://www.ebay.com/itm/274884599036?fits=Year%3A2003|Make%3AArctic+Cat&epid=1278760148&hash=item4000661cfc:g:jYwAAOSwHohhAxGC Share this post Link to post Share on other sites
_Wilson_™ 6,593 Posted August 5, 2021 i think wheeler uses wildwood pads, and bragged on them. 1 Share this post Link to post Share on other sites
Wheeler 2,530 Posted August 5, 2021 My calipers are made by wildwood but were sold as HL disc conversion. The pads I run are EBC 1 Share this post Link to post Share on other sites
DLBeltran74 47 Posted August 13, 2021 (edited) On 8/5/2021 at 12:58 PM, DLBeltran74 said: Has anyone ever heard of wilwood for a four wheeler!?! Ok!!! Geez, just my luck. After I cleaned these up a bit and was getting ready to put them away, I noticed on one of these there was a broken bolt in one of the holes. I tried to get that sucker out but I tried a little too hard and cracked it. Does anyone have a extra driver side one of these? I don’t want to pay $90+ for a new if I don’t have to. Can anyone out there help me out!?! Edited August 13, 2021 by DLBeltran74 Share this post Link to post Share on other sites
Fishfiles 20,147 Posted August 13, 2021 Bummer , that's a needle in a hay stack wish , but you never know !!! Share this post Link to post Share on other sites
_Wilson_™ 6,593 Posted August 13, 2021 man.... that's rough..... you might try posting again (like you did for those handle bar guards) in the parts for sell wanted thread again, you might get lucky... also might try ebay. Share this post Link to post Share on other sites
