Snow Camo

Idk about the cults, I do hear it's where alot of warriors came/ come from.

Ya I love Orion's Belt.

Just trust your instinct

Welcome!

I was thinking. Wait for it...

Had a little time to myself Sunday evening. I went out to the gravel pits/ construction area and had a blast! Rolled it doing a donut. ! near died, but was saved... Need a new handlebar and tierods. May as well ponie up for those uniball rod ends and make me some solid mofos! I'll get spacers front and back as well. Probably 4" in back and 2" in front. Screw those cheap ! ebay tierods!!! Don't risk loosing your life! Both rods popped out the dang joints in the rod! Glad to be alive! Back to work I go! Be safe dudes.

Welcome!

Welcome from Texas! Need more good folks like you!

I figured that would spark an interest. I wanted to post that a while back, but never did.

System error....

Hey fish this one's for you😏

Took the bike for a ride today and got a few pictures. It rides just fine. Scored some ramps for cheap..

Rock on. I did plan to raise the roof a little and smoothing the exhuast port. Thanks for helping me save some money there. That said... now I can fast track to a mukini TM28 flat slide carb. I know you guys may say it is not worth it, but I have to give it a shot lol. I'll figure an intake boot or adapt it. Also freed up some money for exhaust if I choose right. I'll sort through this for a few before deciding. You ever try a flat slide carb on anything?

You know your right. I can do the head myself. I guess it's not that serious where I need to check the valve seats and guides. I'll just have to sort through a C- clamp and socket to pull the retainers. I may as well get a sanding roll to smooth out the casting flaws. I always do that when I open a engine.

I was thinking of having the valves and seats checked. I guess I could just take pics and mic them?

Well I am thinking of sending the head and jug off to get serviced. I got the tires mounted. Eventually I'll get the clutch pack in there.

Welcome!

Ya throttle and choke wide open. I could put some oil inthe cylinder and check again. However I did get get the EBC dirt racer cluch pack and springs. I wonder how the engine runs down the road as is. I'll get it rolling because I have the parts to now.

Hey Wilson and fish here is the compressing conundrum. It's low for sure, so a rebuild is in order. I'll plan that out.

Welcome to an awesome site!