Raystrx350d 47 Posted February 27, 2023 On 2/23/2023 at 8:32 AM, Goober said: At least you’re learning the ignition system!! Are you gettin a new pulse generator? While waiting for parts, continue to inspect and perform electrical checks on wires you may have jostled while doing your other repair work. Use the schematic to double check the kill switch at all those connections on the right front of the quad. get some contact cleaner, permatex dielectric grease and a few plumbers flux brushes. Maybe a brass and nylon gun cleaning brushes. not steel brush. Disconnect and clean all those connections while you’re doing continuity checks—apply a thin film of the grease on the electrical contacts and the backshell of the connectors—you’ll find they snap together and disconnect more easily. Look for weak wires on the harness and subharness. every time i went to start mine i had a steady neutral light. When i cranked it the light would go out. So I swapped the neutral and reverse leads and tried again. Of course the reverse light came on steady and i got it to start—that was a hallelujah moment, because i knew the malfunction was isolated to the neutral wire portion of the circuit. i found the neutral switch connector wire hanging by 2-3 strands. Does your fan come on? Disconnect the oil temp sensor lead and touch it to the footpeg. The oil light should come on steady and fan should come on Yes fan comes on when grounded. 1 Share this post Link to post Share on other sites
jeepwm69 7,719 Posted February 27, 2023 On 2/25/2023 at 5:33 PM, Raystrx350d said: Give me just a min and I will ROFL. Shade knows his stuff, but he's not know for being a patient helper..... 3 Share this post Link to post Share on other sites
shadetree 5,969 Posted February 27, 2023 44 minutes ago, jeepwm69 said: ROFL. Shade knows his stuff, but he's not know for being a patient helper..... you lie !..lol. i spoke to him on the phone..soo..take that !...lol. 1 2 Share this post Link to post Share on other sites
Raystrx350d 47 Posted February 27, 2023 2 hours ago, shadetree said: you lie !..lol. i spoke to him on the phone..soo..take that !...lol. Lol.. he was very informative and patient with me. Stand up guy!! 4 Share this post Link to post Share on other sites
jeepwm69 7,719 Posted February 27, 2023 3 hours ago, Raystrx350d said: Lol.. he was very informative and patient with me. Stand up guy!! Yeah he is. I give him a hard time, but he knows his crap and has walked most of us through some hard stuff. We all like to tease him to get a reaction, but if you listen to him your crap will run again. 2 2 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 2, 2023 On 2/27/2023 at 11:31 AM, shadetree said: you lie !..lol. i spoke to him on the phone..soo..take that !...lol. Still waiting on parts.. be in touch when they come in and get it on. 1 Share this post Link to post Share on other sites
Goober 1,555 Posted March 2, 2023 You’ll find it no doubt. Then you’ll have some hard-to-find spare modules You have aftermarket fuel pump on it? the coil may have color codes on the housing. The important thing about a coil is you have primary and secondary windings. The secondary has more windings (usually) and so the resistance values are different. So if you can’t tell the poles apart. Consult the service manual on coil measurements and put the meter to it. This is why Fish said to remove the coil spark plug cap. Then you inspect the spark plug wire for corrosion and nip off a bit. Then clean the spike end of the cap with a .22 cal bore brush 2 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 2, 2023 2 hours ago, Goober said: You’ll find it no doubt. Then you’ll have some hard-to-find spare modules You have aftermarket fuel pump on it? the coil may have color codes on the housing. The important thing about a coil is you have primary and secondary windings. The secondary has more windings (usually) and so the resistance values are different. So if you can’t tell the poles apart. Consult the service manual on coil measurements and put the meter to it. This is why Fish said to remove the coil spark plug cap. Then you inspect the spark plug wire for corrosion and nip off a bit. Then clean the spike end of the cap with a .22 cal bore brush I do have a after market fuel pump on it, which hasn't been working unless you put power to it with a probe. Odd enough a friend had a cdi box off of a late 90s honda. I plugged it in a heard the fuel pump click on! And it pumps or pulses when spinning it over. Still no spark though. Btw missed fishes post but have tried 4 or 5 coils 2 I knew was working 3 new aftermarket that is in specs. Thanks!! 1 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 3, 2023 On 2/27/2023 at 3:36 AM, Raystrx350d said: Yes fan comes on when grounded. True, already have one and it's installed Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 11, 2023 On 2/21/2023 at 5:51 PM, shadetree said: fuel relay gets its power signal from the pick up coil. this is why the fuel pump only pumps when the engine is being cranked over. I tried, has voltage going to fuel pump relay. Won't pump when spinning over .. a guy had a 2000 honda fourtrax cdi box .. plugged it in.. heard fuel pump or relay click and with that cdi box the fuel pump works.. still no spark though. Thanks! Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 14, 2023 On 3/1/2023 at 10:16 PM, Goober said: You’ll find it no doubt. Then you’ll have some hard-to-find spare modules You have aftermarket fuel pump on it? the coil may have color codes on the housing. The important thing about a coil is you have primary and secondary windings. The secondary has more windings (usually) and so the resistance values are different. So if you can’t tell the poles apart. Consult the service manual on coil measurements and put the meter to it. This is why Fish said to remove the coil spark plug cap. Then you inspect the spark plug wire for corrosion and nip off a bit. Then clean the spike end of the cap with a .22 cal bore brush Got it fixed thanks so much!! 2 Share this post Link to post Share on other sites
Fishfiles 20,147 Posted March 14, 2023 1 hour ago, Raystrx350d said: Got it fixed thanks so much!! What was the problem , someone else might be following the thread Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 14, 2023 I posted the problem on shadetrees post. He had me to put the old stator back in and there was a bad wire in the harness ( stator ) harness. I posted it there because I see so many people not come back and post the problem to help someone else. Thanks again for all the help. If not for Shadetree I would have gave up on it lol.. 1 2 Share this post Link to post Share on other sites
jeepwm69 7,719 Posted March 14, 2023 I tease shade a lot on these forms, but I tease all my friends. Few people in this world know as much about old Hondas as he does, and even fewer will take the time to use that knowledge to help out another. 3 1 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 14, 2023 He's a stand up guy! He was really good helping me.. & I definitely appreciate it..like I said before if it wasn't for him I would have probably gave up on it! 3 1 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 23, 2023 On 2/26/2023 at 12:38 AM, shadetree said: i'm going to pm you. 2 Share this post Link to post Share on other sites
shadetree 5,969 Posted March 23, 2023 2 hours ago, Raystrx350d said: ooooooooo... a blue one !!..thats solid gold right there ray !!. 1 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 23, 2023 20 minutes ago, shadetree said: ooooooooo... a blue one !!..thats solid gold right there ray !!. Thanks for all your help!! Not sure if you saw the other messages or not but wooo hooo got fire!! I really appreciate your help.. if not for you I would have Gave up on it .. Share this post Link to post Share on other sites
shadetree 5,969 Posted March 23, 2023 9 minutes ago, Raystrx350d said: Thanks for all your help!! Not sure if you saw the other messages or not but wooo hooo got fire!! I really appreciate your help.. if not for you I would have Gave up on it .. all good ray, glad i could help a bro in need !. 2 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 31, 2023 On 3/23/2023 at 3:03 PM, shadetree said: all good ray, glad i could help a bro in need !. On 3/23/2023 at 3:03 PM, shadetree said: all good ray, glad i could help a bro in need !. 1 Share this post Link to post Share on other sites
Raystrx350d 47 Posted March 31, 2023 Just now, Raystrx350d said: Thanks again shadetree, runs great. I had some old lemon twist yellow and black laying around and this is the result lol 1 1 Share this post Link to post Share on other sites
_Wilson_™ 6,591 Posted April 1, 2023 4 hours ago, Raystrx350d said: Thanks again shadetree, runs great. I had some old lemon twist yellow and black laying around and this is the result lol Too good! I'm not laughing at the change, but at the impending response Rolf! 1 1 Share this post Link to post Share on other sites
shadetree 5,969 Posted April 1, 2023 9 hours ago, Raystrx350d said: Thanks again shadetree, runs great. I had some old lemon twist yellow and black laying around and this is the result lol i hate yellow, and what the heck is up with the yamaha rims ??..thats a honda sin !!!..lol. 3 Share this post Link to post Share on other sites
Raystrx350d 47 Posted April 1, 2023 17 hours ago, shadetree said: i hate yellow, and what the heck is up with the yamaha rims ??..thats a honda sin !!!..lol. I honestly didn't know they were yamaha rims lol.. just paint I had laying around I was broke you made me buy all honda parts lol 1 2 Share this post Link to post Share on other sites
Raystrx350d 47 Posted April 1, 2023 22 hours ago, _Wilson_™ said: Too good! I'm not laughing at the change, but at the impending response Rolf! Lol I was expecting a a** chewing 😅 1 Share this post Link to post Share on other sites