TBRider

You could only drive it in straight lines....lol

Trax are on backwards, might be cause of the fenders, but that would be fun.

Went for a spin on the bike today, beaver dams have about a foot of ice now so I can go and get the trees from the middle, dry as a bone bark fallen off, gives amazing heat, from standing to the stove in under an hour.....

My winch sits so low in the front I added a wheel off the front rack to get more lift out of mine.

I usually used an old seatbelt out of an old van, but I didn't swap it out this year.

Nope, and here's what the last one looked like when the cable broke..... I've pulled it through the rollers a few times.

This is what I used, they were in town at a nut and bolt store so no link. Guys that do garage doors might have them also.

It was the crimping kind but I just use a big hammer....!

Broke my winch cable plowing snow the other day so I had to get a new compression end for the cable....cost me .63 cents......lol

We have a form for hurt feelings here......🤣🤣🤣

Yup, it was -22C here this morning (-6F) sun is shining here now -9C and little wind....

Cold overnight here, woke up to -20C, nice and warm in the house with all the stoves going. Might have to fix my winch cable down in the basement today

Woke up to a cold morning here, -12C (13F). Its apparently going to stay cold for a few days which is good, stuff should start to freeze up good enough to travel over without breaking through.

They look like a decent tire, I'd probably try them if they were cheap....

Welcome to the site, I'm from northern New Brunswick

When I was rebuilding the front end of my King Quad, I used the winch to almost stand the bike up so it was easier for me to work on.

Welcome to the site

I just lift the nut with some zip tie cut offs laying on the shop floor. Lift nut tighten bolt remove zip ties...

A dusting of snow yesterday temps are staying just around freezing. And it looks like its trying to snow again this morning

I only like the donairs from here and from the donair shop on Macleod in Calgary

Here fish, this is how we have our donairs... https://www.mediocrechef.com/blog/best-halifax-donair-recipe

I had to do this installing a satellite on a metal roof in the winter.... We used a big payloader to hold the ladder in place laying on the metal roof. OH&S approved back here....🤣🤣👍