-
Content Count
844 -
Joined
-
Last visited
-
Days Won
3
Content Type
Profiles
Forums
Gallery
Calendar
Everything posted by Melatv
-
HI: This may help -- Cut a V notch see picture
-
HI: This maybe what you are looking for
-
HI: This maybe your problem -- check the large wire from the positive of the battery going to to the solenoid -- the 2 small red wire should go on the stud with that large wire.
-
12 volt cigarette lighter connection 2003 Honda Rancher
Melatv replied to Greg's topic in Electronics
Hi: Try this -
Hi: Here is a good read for red hot exhaust 12 Most Common Reasons for a Glowing Red Hot ATV Exhaust | BoostATV.com
-
Hi: If you still have the FMC connected on your 450 -- it only gets it 12VDC from the FMC -- the sensor tells the FMC to turn the fan on.
-
I have the same service manual -- Fan motor -- section 20-2
-
Where do you see that in the service manual?
-
That is the Fan motor not the engine Section 20-2
-
Hi: I have never found a ATV that the Fan Motor Control would shut down the CDI -- that would be a unsafe thing to do -- can you see a ATV climbing a ice or slipper hill and the bike shut off -- when needed the power to get to the top safely what going to happen to the ATV & ATVer? As far as the 86 350 the is no connection (no Connection) between the Fan Motor controller and the CDI Some of the newer ATV will go into limp mode -- but not shut down The Fan Motor Control only controls the Oil Temp Light and Fan motor when the Oil Temperature Sensor is calling for the Fan to turn on.
-
There are places here in New Brunswick Canada where ATV's use streets along with cars -- even parking place for ATV at some stores. Green line shows ATV routes to places to eat & shop. We also Highway usage permits on some roads to get to ATV trails.
-
Hi: The coil needs a 100 + on the primary side-- I noticed that the wiring diagram (21-1) has the wrong color code on the N&R change switch -- refer to section 18-0 to change it to make it right.
-
Buy a NGK IRIDIUM plug
-
Very sorry to hear about what your wife is going through -- hope everything goes well.
-
Birds are skating on the bird bath this morning
-
Axle nut - Honda Foreman 400
Melatv replied to 1997Foreman400's topic in Brakes - Suspension - Steering
Sorry I got things wrong -- just did the front brakes on a other bike --- it will work the same for the rear -
Axle nut - Honda Foreman 400
Melatv replied to 1997Foreman400's topic in Brakes - Suspension - Steering
Hi: This should help when aligning the shoes -- first measure the in side of the drum -- then measure from tip to tip of the shoes -- see green and red lines to get them even before place the drum. -
Axle nut - Honda Foreman 400
Melatv replied to 1997Foreman400's topic in Brakes - Suspension - Steering
Hi -- that would be a 30 MM socket -
Hi Sled_22: I like the setup for for building the frames
-
2002 Rubicon front suspension squeak
Melatv replied to BC-Buck's topic in Brakes - Suspension - Steering
Hi: Remove bolts and use grease -
Hi Ast M: Try testing the rectifier this way. Here is something I made up for testing the rectifier. If anyone want to add to this do so.
-
Hi: Code 22 Shift angle sensor
-
Hi: They come in !2 mm and 9/16" -- those maybe mm