General ATV Discussion

Replaced brakes and master cylinder bleed brakes and master cylinder even tried using a vacuum pump any ideas? Did replace the master cylinder with an Amazon one that they said fit it I don't know any ideas?

It's very hard to turn and tires kinda slid wind you turning not a very tight turn radius 

So you aren't getting any peak voltage at the Black/yellow coil wire?     Try reversing the polarity of the Peak Voltage Adapter leads between Black/yellow and ground on the coil (positive PVA lead on Black/yellow, negative PVA lead on ground) and see if you get any peak voltage?   Your multimeter should be dialed to DC volts mode, since the PVA uses a diode to capture 1/2 waves of the CKP sensor AC sine wave voltage and stores those 1/2 waves (now rectified DC rather than AC voltage) in a capacitor inside the PVA.

AKATV, can I get your contact info got a couple meters I need repaired. Thanks 

So.... what I'm saying is your gear position switch is fine, else the neutral light would not light up on the display and the starter would not work when you press the starter button.   Your no spark issue is a head scratcher for sure!