New Member Intro

just attempted to put back together for over 2 hours. still wont go down. i took all the bearings out of the case made sure they were in the right place and seated trans is seated crank and counter shaft are seated and pins are in place. still wont go down. last time i split the case i didnt have any issue putting it back together. i believe its something on trans side but as far as i see everything is seated properly

Your machine is full time 4wd.  It will steer much easier if you covert to selectable 4wd.    

Do they have limited slip on front or rear mine won't slip at all even going around turns makes it hard to turn 

I gather from your other post (in the old dead forums)..... mice ? To stop them 100% pure peppermint (oil or escents) spray and moth balls... and that hand <<< (IDIOT) advising you to wrap the insulated wires in steel wool ?..... SUPER bad advise.... it will not prevent them from starting NOR stop them once they have ....glue traps are are a added plus.... to bullet proof... add peanut butter AND seasoned salt meat or bacon.

what part are you looking for ?. i know most of the atv's in his bone yard do not have fan control units, or c.d.i.'s ?, the engines in the frames have not been torn into yet though. then there is the problem of locating a 1988 model, which you are after. i will pm you his cell, you can call him, ask him if he can help you, but i can tell you right now, i'll be the one pulling the part/parts..lol.